Core update 136, Squid Clamav, Clamav not running...

General questions.
Post Reply
PM47
Posts: 12
Joined: September 4th, 2011, 7:38 am

Core update 136, Squid Clamav, Clamav not running...

Post by PM47 » October 11th, 2019, 9:18 am

I've just run core update 136 and rebooted. I have the Squidclamav and Clamav addons. The Network/Web Proxy page now reports 'SquidClamav - Clamav not running'. I've uninstalled and re-installed both with no change. As far as I know Clamav was Ok with core update 135. Any suggestions please ??

IpFire core update 136 running in Virtualbox on Linux Mint 19. Standard install + SquidClamav and Clamav.

PaulM

User avatar
Arne.F
Core Developer
Core Developer
Posts: 8516
Joined: May 7th, 2006, 8:57 am
Location: BS <-> NDH
Contact:

Re: Core update 136, Squid Clamav, Clamav not running...

Post by Arne.F » October 11th, 2019, 9:20 am

ClamAV need some time to update the Databases. Have tried again after a while or any logoutput.
Arne

Support the project on the donation!

Image

Image

Image
PS: I will not answer support questions via email and ignore IPFire related messages on my non IPFire.org mail addresses.

PM47
Posts: 12
Joined: September 4th, 2011, 7:38 am

Re: Core update 136, Squid Clamav, Clamav not running...

Post by PM47 » October 11th, 2019, 3:14 pm

Yes, it's now running thanks.

It usually takes a few minutes to update the Clamav databases (70Mbps connection). This time it appears to have been several hours. Not sure why, but it's now running so problem solved.

PaulM

Post Reply