Just installed ipfire on a Netgate APU4, which has a PC engines APU1D4 mb. Ipfire seems to be running great, but I noticed that the sd card is formatted ext4, which makes me wonder if there will be wearout problems over time on the sd card. Is there any kind of advice or a checklist to minimize sd wearout problems? I already verified there's no swap partition, and I could configure remote syslog so it doesn't write log files. Anything else? Is this even something to worry about?
TIA!
Running on bare SD card?
Re: Running on bare SD card?
If you have used the flash image, the card is formated as ext4 without journaling. This should be the best mode for flashcards...
Arne
Support the project on the donation!



PS: I will not answer support questions via email and ignore IPFire related messages on my non IPFire.org mail addresses.
Support the project on the donation!



PS: I will not answer support questions via email and ignore IPFire related messages on my non IPFire.org mail addresses.