[Solved] HDD S.M.A.R.T. info w/ RAID Controller via WUI

Questions & Discussion about the right Hardware to run IPFire on
Post Reply
User avatar
cbrown
Posts: 12
Joined: December 29th, 2017, 11:54 pm
Location: Texas

[Solved] HDD S.M.A.R.T. info w/ RAID Controller via WUI

Post by cbrown » March 8th, 2019, 3:26 pm

I have a 3ware 2-port raid controller in a system setup with raid-1.
I can get the hard drive S.M.A.R.T. info via the following shell commands:

Code: Select all

smartctl -a -d 3ware,0 /dev/twa0
smartctl -a -d 3ware,1 /dev/twa0

Is there a configuration change needed to get the S.M.A.R.T. info from the WUI?
Currently the WUI shows the follwing when I click on the S.M.A.R.T. Info button.
smartctl 6.6 2017-11-05 r4594 [x86_64-linux-4.14.86-ipfire] (IPFire 2.21)
Copyright (C) 2002-17 Bruce Allen Christian Franke www.smartmontools.org

Smartctl open device: /dev/sda failed: AMCC/3ware controller please try adding '-d 3ware N'
you may need to replace /dev/sda with /dev/twlN /dev/twaN or /dev/tweN
Last edited by cbrown on March 9th, 2019, 1:53 pm, edited 1 time in total.
Image

User avatar
cbrown
Posts: 12
Joined: December 29th, 2017, 11:54 pm
Location: Texas

Re: HDD S.M.A.R.T. info w/ RAID Controller via WUI

Post by cbrown » March 8th, 2019, 10:29 pm

media_smart.JPG
Image

User avatar
Arne.F
Core Developer
Core Developer
Posts: 8086
Joined: May 7th, 2006, 8:57 am
Location: BS <-> NDH
Contact:

Re: HDD S.M.A.R.T. info w/ RAID Controller via WUI

Post by Arne.F » March 9th, 2019, 12:01 pm

There is no function in the webif to ask a different device to get the s.m.a.r.t data from a drive.
Arne

Support the project on the donation!

Image

Image

Image
PS: I will not answer support questions via email and ignore IPFire related messages on my non IPFire.org mail addresses.

Post Reply