Outdoor Wifi Antenna

Questions & Discussion about the right Hardware to run IPFire on
Post Reply
Posts: 1
Joined: October 4th, 2018, 10:54 pm

Outdoor Wifi Antenna

Post by Techforce » October 4th, 2018, 11:06 pm

Looking to get an outdoor Wifi Antenna hooked up and they seem to terminate in USB, I guess into the very popular Wireless routers.

Im using Ipfire on an older Pentium3 machine and its got I believe (2) USB 1.0 ports.

Is there any chance of developing USB wireless support for Ipfire at all?

User avatar
Core Developer
Core Developer
Posts: 8522
Joined: May 7th, 2006, 8:57 am
Location: BS <-> NDH

Re: Outdoor Wifi Antenna

Post by Arne.F » October 9th, 2018, 11:39 am

IPFire already support Wireless Cards via USB2.0 e.g. Ralink RT5572 based devices. (This chipset is also used in the IPFire DUO.) Also other Chipsets from Zydas or Atheros (9K-HTC) are supported.

https://wiki.ipfire.org/hardware/networking scroll down to USB WLAN-Adapter

USB 1.0 (1.5mbit raw Data Rate) will not supported by any Wireless Chip.
USB 1.1 (12mbit works with some chipsets but is slooooooow.... (ca 4mBit data transfer because the raw rate is devided by two and there is overhead)

Support the project on the donation!



PS: I will not answer support questions via email and ignore IPFire related messages on my non IPFire.org mail addresses.

User avatar
UAW-Chrysler NTC
Posts: 16
Joined: October 23rd, 2018, 10:29 am

Re: Outdoor Wifi Antenna

Post by UAW-Chrysler NTC » January 9th, 2019, 6:57 pm

Hardware is so cheap and accessible.
Why not just upgrade your hardware.
Even if it was doable the performance would be lacking :)
You will enjoy thing more if you just upgrade your equipment.
UAW-Chrysler NTC |Warren, Michigan, USA
IPFire 2.21 (x86_64) - Core Update 126

Post Reply