Ethernet Shield for Raspberry EthernetBerry Dual V 1.1

Questions & Discussion about the right Hardware to run IPFire on
Post Reply
Jack4422
Posts: 4
Joined: November 13th, 2018, 6:48 pm

Ethernet Shield for Raspberry EthernetBerry Dual V 1.1

Post by Jack4422 » November 1st, 2019, 6:53 am

Hi guys,

I was wondering if such a hardware would work with IpFire. Thanks for your help.

http://www.industrialberry.com/ethernetberry-v-1-1/

Kindest regards,

Pierre

User avatar
Arne.F
Core Developer
Core Developer
Posts: 8522
Joined: May 7th, 2006, 8:57 am
Location: BS <-> NDH
Contact:

Re: Ethernet Shield for Raspberry EthernetBerry Dual V 1.1

Post by Arne.F » December 16th, 2019, 5:33 pm

Not without hacking a new dtb file that assign the spi-bus and enc28j60 devices. And it is slow. This chip support only 10Mbps and need a fast spi. Im not sure if the rpi can handle the speed via spi.
Arne

Support the project on the donation!

Image

Image

Image
PS: I will not answer support questions via email and ignore IPFire related messages on my non IPFire.org mail addresses.

Post Reply