after reboot HPE NC382T not starting

General questions.
Post Reply
User avatar
neopegasus
Posts: 35
Joined: July 12th, 2016, 11:15 pm

after reboot HPE NC382T not starting

Post by neopegasus » July 12th, 2019, 6:50 pm

Hi everyone a just installed a HPE NC382T a week or two ago, but if I reboot the box , the lan do not start up.
It will start up after I put a monitor and a keyboard and go in the nc382t bios, after I just go in the bios and check everything and shutdown and start up again then it will work again. Is this something I am missing in my ipfire setting?

I just upgrade the box with New fan and this nic ( I had USB lan before)


Best regards

Neopegasus
Image

User avatar
neopegasus
Posts: 35
Joined: July 12th, 2016, 11:15 pm

Re: after reboot HPE NC382T not starting

Post by neopegasus » July 13th, 2019, 1:09 pm

I did some change yesterday night and let it run , today (around 14 hour uptime) I reboot it to check ( I normally would have the problem), and the reboot went ok, it seems like I have some problem with power supply.
the HPE NC382T is in the pci-e x16 of the board ( as I don't have more pci-e) and have ventilators connected to the main board as normal but it seems they draw to much power because after i remove the fan's and connected directly and also remove nic I was not using any more ( one for orange ) yesterday it is now rebooting without the problem when I reboot.

I will conduct more test and see
Image

Post Reply